The 5 Channel Calibrator is designed to interface CEM analyzers with five individual calibration gasses. The gasses can be controlled manually or remotely to flow through one of two calibration ports. Sub-Rack designed for installation into a standard 19" instrument rack. Flow-meter with stainless steel needle valve provides indication and control of calibration gas flow rate from 1 to 10 lpm. Auto Mode allows a data acquisition system equipped with a dry contact closure to control the calibration points remotely. A 12VDC output signal is provided for use by the control system via an Amphenol connector located on the rear of the 5 Channel Calibrator. 
Stack Tester Comments :
We use the 5-Channel Calibrator to manage the FID cal gas to the probe tip in combination with the FLW-6 for all the other dry gas analyzers. The 5- Channel is also great when we are only running one or two analyzers or when we have many analyzers and don't need all the functions of the FLW-6.
The solenoid values require properly maintained gas cylinder pressure regulators to ensure the gas pressure to the solenoids never exceeds 40 psig. Pressure regulators which cannot control pressure with zero flow should not be used.
Features
Flow meter with stainless steel needle valve provides indication and control of calibration gas flow rate from 1 to 10 lpm.
AUTO Mode allows a data acquisition system equipped with a dry contact closure to control the calibration points remotely.
A 12 VDC output signal is provided for use by the control system via an Amphenol connector located on the rear of the calibrator. Sub-Rack Design for installation into a standard 19" instrument rack.
Español
